Automatic Mask Production Line / Plat Mask Fully Automatic Production Machine / One Drag Two Plane Mask Machine

Technical Specifications:
1) Equipment diagram (layout, due to different product models, pictures are for reference only):


2) Basic configuration
a) None woven fabric feeder, spool diameter ≤600mm:
     i)  Mechanical material feeder rack;  
    ii) Manual feeding, the equipment automatically feeds.

b) Melt blown fabric feeder, spool diameter ≤600mm:
      i)  Mechanical material feeder rack;
      ii) Manual feeding, the equipment automatically feeds.
c) Fabric filter feeder, spool diameter ≤600mm:
       i)  Mechanical material feeder rack;
      ii)  Manual feeding, the equipment automatically feeds.
d) Elastic cord forming devices.
e) 4 sets of ultrasonic spot welder.

3) Automation system configuration
   a) PLC-touch screen, servo motor system.
   b) Production output target and the actual output status will display on the touch  
     screen.
  c) All material shortages will be automatically detected and shut down by itself if    
     needed.
 d) Others safety features - Auto self-tripping mechanism if any electrical
     component failure found.

4) Major Component Supply Base                          
5) Equipment Introduction
This equipment is mainly design for plane ear strap mask production(One drag two). The raw material - different fabric spool will load upon the designated feeder rack (max can expand up to 4 spools). The ultrasonic welding technology use along with the other automation mechanism, start from roll welding, elastic loop feeding, trimming and eventually blank folding after sonics weld. The last process will be the nose bridge press to the nose level position.  Then the finish goods face mask finally formed and the system will automatically count as final product.
a) Equipment Features
 i) The whole set of equipment operate in highly automation mode.
 ii)  High stability and low failure rate.
 iii) PLC and servo control system.
 iv) Module design, convenient maintenance.
 v) Effectively avoid the secondary pollution caused by manual taking of masks.

b) Production capacity
  i)  Production efficiency: 90 ~ 110 pieces/minutes.
  ii) Equipment production pass yield: 96% (except for incoming materials that do not meet the requirements and improper operation of employees).

6) Training
After the installation and commissioning of the equipment done, the relevant  personnel of the buyer team will be trained (free of charge) at the supplier site. The training content     includes the safe operating procedures of the equipment,  precautions, daily maintenance and the justification and elimination of faults.

7) Material specifications
Commissioning equipment raw materials: non-woven fabric (width 195mm), melt-blown fabric (width 175mm), Anionic fabric (width 175mm), elastic cord, nose-bridge & etc need to be provided by the buyer.

8) Attach guideline / wearing part
    a) One copy of the equipment instruction manual;
    b) One copy of electrical schematic diagram;
    c) The wearing parts such as knives, scissors, timing belts, flat belts, cylinders are not under warranty.